Working on my half bath has me thinking about other bathroom makes I’ve done. Built this vanity last year and mannnn it felt GOOD! Krazy Glue is my favorite, you’ve seen me use it before!! Bonds many surfaces (like wood!!!) and bonds in minutes — cures completely in 24 hours 😱

1. Using 3/4 inch plywood (I used white oak) cut down an 8×4 sheet.
2. Miter the edges, using a table saw at a 45° angle. (Check out this post for more tips on mitering.)
3. Using Krazy Glue Wood Glue, attach the edges together. Hold together with clamps.
4. Cut out a hole for the drain + faucet.
5. Sand the edges nice and smooth.
6. Stain the vanity. (I used white wash + provincial makes for the prettiest combo.)
7. Attach the brace to the wall on the two sides and along the back.
8. Place the vanity on top. The weight of the sink will hold the vanity in place. You can caulk around the edges of the vanity and the wall to finish it off.

View this post on Instagram

A post shared by Kenna Valdez | the flip hubb | DIY & Design (@thefliphubb)

Would you build your own?

Xo,

Kenna

Paint is Cracked Pepper by @sherwinwilliams in eggshell

Countertop is @varathane white wash & early American stain

Sink is @homedepot

Faucet is @wayfair

Tile is old and from me hoarding it for years.